Lehrstuhl für Statik und Dynamik
Universitätsstraße 150, 44801 Bochum
+ 49-234-32-29051
The publication with the full title "Blind competition on the numerical simulation of slabs reinforced with conventional flexural reinforcement and fibers subjected to punching loading configuration" (DOI: 10.1002/suco.202400061) has been published in the journal "Structural Concrete" by Wiley.
Abstract:
This paper describes the 3rd Blind Simulation Competition (BSC) organized by the fib WP 2.4.1 which aims to assess the predictive performance of models based on the finite element method (FEM) for analysis and design of fiber reinforced concrete (FRC) structures submitted to loading and support conditions that promote punching failure mode. Fiber reinforcement is used in an attempt to eliminate conventional punching reinforcement and provide technical and economic advantages. The two tested real-size prototypes represent a column-slab interior region of an elevated steel-fiber reinforced concrete (E-SFRC) slab where anti-progressive collapse reinforcement is disposed in the alignment of columns/piles. Despite a punching failure surface being formed in both experimentally tested prototypes at the rupture stage, fiber reinforcement was able to mobilize the yield capacity of the conventional flexural reinforcement, providing high deformation capacity, and ductility to the prototypes. The average post-peak load-carrying capacity of the tested prototypes at a deflection seven times higher than the deflection at yield initiation of the conventional reinforcement was still 90% of the average peak load. Regarding the BSC, a total of 26 proposals were received and involved 94 participants from 29 institutions and 17 countries, with 53.9% using smeared crack models (SCMs), 30.8% a concrete damage plasticity (CDP) model, 3.8% discrete crack models (DCMs) and 11.5% considered as “other models.” From these simulations it was verified, in average terms, that SCM assured the best predictive performance apart from the average strain in the SFRC and the maximum crack width which were better predicted by DCM. More accurate predictions were obtained by using in-house software than by adopting commercial software.
https://doi.org/10.1002/suco.202400061
"Multiscale tests, simulation, optimization and 3D printing of UHPFRC materials and structures" is t
mehr...